본문 바로가기
mobile,IT

ESR 맥세이프 차량용 무선 충전기 리뷰 #1 (magsafe wireless car charger, 차량용 충전기, 아이폰12)

by 잡초 2020. 12. 18.

Aliexpress에서 구매한 차량용 맥세이프 무선 충전기를 리뷰합니다.
차량에 기존 샤오미 무선 충전기를 사용하였으나, 아이폰12미니의 경우 사이즈가 작아서 기존충전기에 잡히지가 않습니다. (두꺼운 케이스쓴다면 가능하지만.)
이번 제품은 맥세이프 자석을 활용하여 폰을 고정하기 때문에 휴대폰을 잡아주는 집게가 없습니다.
Review the vehicle Magsafe wireless charger purchased from Alixpress.
I used an existing Xiaomi wireless charger for my vehicle, but the iPhone 12 mini is too small to be caught by the existing charger. (It's possible with a thick case.)
This product uses the magnet from Magsafe to fix the phone, so there are no tongs that hold the cell phone.

Below is a box.
아래는 박스 모습입니다.

박스 뒷면

박스를 개봉했을떄 구성품은 아래와 같습니다.
본체, 뒷면클립, 충전케이블, 설명서가 들어있습니다.

When the box is opened, the components are as follows.
Contains wireless chargers, rear clips, charging cables, and documentation.

구성품


설명서 내용입니다.
폰을 잡아주는 집게는 없지만, 송풍구를 잡아주는 후면 집게는 존재하는것을 알수있지요?
USB-C타입으로 충전되며, 반대편은 USB-C타입이아니라 기본 USB타입이라고 보시면됩니다.

This is the documentation.
There are no tongs that hold the phone, but you can see that there are tongs that hold the fan, right?
It is charged with USB-C type, and the other side is not USB-C type, but a basic USB type.


송풍구가 가로모양만 되느냐? 그렇지 않습니다.
뒷면 집게가 360도로 돌아가기때문에 세로 송풍구도 가능합니다.
사진에는 가로를 예시로 나와있네요.
후면에는 집게 외에도 지지대가 별도로 있어서 흔들림을 방지해줍니다.

It's not just horizontal blasts.
The rear tongs rotate 360 degrees, so vertical vents are also possible.
The picture shows the horizontal as an example.
In addition to the tongs, there is a separate support on the back to prevent shaking.

송풍구 장착 예시


제품에 LED등이 장착되어 있습니다.
LED등에 따라 제품이 어떤상태인지 알수있습니다.
-5초동안 LED On표시: 제품을 USB포트에 전원연결했을때.
-LED Off: 제품 대기상태(폰 미장착)
-LED On: 충전중/충전완료
-LED flashing: 에러발생
에러가 발생했을때는 휴대폰 뒷면에 신용카드/스탠드/다른 금속물질이 없는지 확인하고, 전원케이블을 재연결할것을 알려줍니다.

중요한 점은
1. 최대충전속도를 내려면 QC 2.0/3.0 또는 PD 충전에 호환되는 케이블과 어댑터를 사용해야합니다.
2. 케이스 두께가 5mm가 넘는 제품은 호환되지 않습니다. (정품 맥세이프 카드케이스도 되는지는 확인이 필요할것같습니다.)

The product is equipped with LED lights.
Depending on the LED light, you can see the status of the product.
- LED On display for 5 seconds: When the product is plugged into a USB port.
-LED OFF: Product standby (without phone)
-LED ON: Charging/Recharging Complete
-LED FLASHING: Error occurred
If an error occurs, check the back of the phone to see if there are no credit cards/standings/ other metals, and tell them to reconnect the power cable.

the point is
1. To achieve maximum charging speed, you must use a cable and adapter compatible with QC 2.0/3.0 or PD charging.
2. Products with case thickness greater than 5mm are not compatible. (We will need to check if the original MagSafe card case is also available.)


제품 전면부 모습입니다.
필름을 제거하기 전입니다.

This is the front of the product.
This is before the film is removed.


뒷면모습입니다.
ESR이 2009년부터 있었군요.

This is the backside.
ESR has been around since 2009.

하단부 USB-C타입 연결부를 확인하실 수 있습니다.

You can check the USB-C type connection at the bottom.

The tongs to be attached to the back.


집게가 쉽게 벌려지진않습니다.
주의깊게 볼것은 집게 아래에 무게를 지탱할 지지대가 있습니다. 이것도 각도를 조절할수 있습니다.

The tongs don't open easily.
The thing to watch out for is that under the tongs there is a support to support the weight. You can also adjust the angle.


후면 집게는 이렇게 세로로도 잡을수 있습니다.
그리고 지지대에도 미끌림방지 처리가 되어있습니다.

You can hold the rear tongs vertically like this.
And the support is also anti-slip.


포함된 충전케이블입니다.
Included charging cable.

 
충전기에 맥세이프케이스를 씌운 아이폰12미니를 부착한후 테스트를 해보았습니다. 케이스도 ESR 제품입니다.
격하게 흔들어도 쉽게 떨어지진않았습니다.

I tested it after attaching the iPhone 12 Mini with the MagSafe case on the charger. The case is also an ESR product.
It didn't fall easily even if I shook it violently.


이상으로 개봉기를 마칩니다.
다음에는 차량에 부착하여 포스팅하도록 하겠습니다.

좋아요는 저에게 많은 힘이 됩니다.
감사합니다.

That's all for the review.
Next time, we will attach it to the vehicle and review it.

Like gives me a lot of strength.
Thank you.